Add a Bungee Ball Cord to your Handle Holder for added support and stability. This will work on both versions of the Wall Control Handle Holder, the 2in (10-HH-3050) and 1-1/4in (10-HH-2050) Handle Holder Brackets. It is typically easier to do this while the bracket is on a panel.
Step 1
Slide the bungee cord behind the Handle Holder.
Step 2
Pull the bottom loop up and then pull the ball through the loop.
Step 3
Pull the bungee ball so the cord is tied tight against the bracket.
Step 4
Stretch the bungee cord over each side of the Handle Holder Bracket.
Step 5
Start Storing!
When you're ready to store, pull the bungee ball towards you to create an opening. Then slide in your desired tool into the Wall Control Handle Holder!